Today, there are far more diesel vehicles than gasoline. Therefore, the probability of encountering problems related to diesel engines in your workshop is quite high. One of the problems happens when, when replacing glow plugs, one of them parts gets stuck in the head of the engine.
Usually this involves disassembling the motor head of the engine block only to remove a small piece of the plug. Can you imagine the number of hours it takes just to do that?
Fortunately KROFtools has a kit to solve this problem quickly and almost in a surgical way. Ready to see how the demaged glow plug removal set kit works? Let’s do it!
9 Steps to use the Glow Plug Removal SET
- An glow plug breaks for a variety of reasons, but there are few better solutions than these kits.
2. Start by installing the appropriate drill on the engine head.
3. Now drill a hole in the tip of the glow plug. If the situation does not allow this, do not drill a hole to prevent the debris from going into the engine combustion chamber. Be careful not to damage the piston.
- After that, insert the appropriate threaded male and thread into the hole.
- Remove the drill and install the extraction piece.
- Insert the extraction rod that matches the thread made and screw into the glow plug
- Now insert the extraction female into the stem and tighten until it pulls against the guide piece .
- Finally, to remove the glow plug, tighten the extraction female.
- The rod is pulled up while keeping tangled in the plug removing it from its place.
There is no better way to save time as doing it properly and faster.
Subscribe to our YouTube channel,whereyou can watch this tutorial and turn on notifications to keep you up to date with all the news.