casquilho braço suspensão

How to use the Trailing arm bush tool for Volvo and Ford

In this article we want to show you how to use the installation and removal KROFtools kit  suitable for the Trailing arm bush tool for Volvo and Ford.

In the automotive industry, there are several particularities between the various brands and models. The Volvo and/or Ford suspension arm is a good example of this. When it is necessary to replace one of your bearings or bell blocks, you cannot do so it with any tool. That’s why KROFtools created this tool for installing and removing bearings.

Ready to see how it works? Let’s do it!

 

4 steps to use the Trailing arm bush tool for Volvo and Ford

  1. To remove a bell block, it is only necessary to assemble the kit with the bearing on the side of the opening and the spacer covered on the side of the spindle.

2. You should then tighten the spindle until the bell block comes out of the housing entirely.

3. To properly install the bell block, it is necessary to tight the side plates to the spacer.

4. These plates guarantee the correct distance in the installation, from the face of the housing to the face of the bell block.

With this KROFtools tool kit, changing the Volvo and/or Ford suspension arm bell block will always be an easy job ! Fantastic, don’t you agree?

Subscribe to our YouTube channel, where you can watch this tutorial and turn on notifications to keep you up to date with all the news.

Leave a Reply

Your email address will not be published. Required fields are marked *